Yes, it is possible to push start a carbureted motorcycle. Push starting, also known as bump-starting or roll-starting, is a method of starting a motorcycle without using the electric starter. Here's how you can push start a carbureted motorcycle:
Ensure the ignition is turned on: Make sure the motorcycle's ignition switch is in the "On" position.
Get the motorcycle moving: Push the motorcycle to gain some speed. You can either have someone help push it or use your feet to push off the ground while seated on the motorcycle.
Engage the clutch: Once the motorcycle is moving at a reasonable speed, pull in the clutch lever completely to disengage the engine from the transmission.
Select a gear: Shift into second or third gear (typically), as these gears provide a good balance between torque and speed.
Release the clutch: While still rolling, release the clutch lever gradually and smoothly. As the clutch engages, it will transfer power from the moving motorcycle to the engine, causing it to turn over.
Apply throttle: As the engine starts to turn over, give a little throttle to provide fuel and air to the engine. Be careful not to give too much throttle initially to prevent the rear wheel from locking up.
Release the clutch completely: Once the engine fires up and starts running, release the clutch lever fully and continue riding.
It's important to note that push starting a motorcycle should be done in a safe environment, away from traffic, and preferably on a slight downhill slope. Additionally, push starting may not be effective if the battery is completely dead or if there are underlying mechanical issues preventing the engine from starting. If push starting fails or you encounter repeated starting difficulties, it's recommended to have the motorcycle inspected by a qualified mechanic.