+8 votes
in Motorcycle Mechanics and Maintenance by
edited by

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
+1 vote
by

It is strongly recommended to avoid running your motorcycle while changing the oil. Changing the oil typically involves draining the old oil from the engine and replacing it with fresh oil. Running the motorcycle during this process can lead to several issues:

  1. Hot oil: The oil in the engine becomes hot during operation. If you attempt to change the oil while the engine is running or shortly after shutting it off, the oil will be extremely hot and can cause severe burns if it comes into contact with your skin.

  2. Oil circulation: Running the engine while changing the oil can cause the fresh oil you're adding to mix with the old oil that is being drained. This can contaminate the new oil and reduce its effectiveness.

  3. Inadequate drainage: Running the motorcycle while changing the oil can prevent the oil from fully draining out. The oil pump may continue to circulate the oil through the engine, preventing you from removing all the old oil. This can result in incomplete oil changes and can leave behind sludge, debris, or contaminants in the engine.

  4. Safety risks: Working on a running motorcycle increases the risk of accidents and injury. It is best to work on the motorcycle in a stationary and secure position to ensure your safety.

To properly change the oil in your motorcycle, follow these general steps:

  1. Ensure the motorcycle is parked on a level surface and turned off.

  2. Place an oil drain pan beneath the motorcycle's oil drain plug.

  3. Remove the drain plug and allow the old oil to drain completely into the pan.

  4. Once the oil has drained, replace the drain plug and tighten it to the manufacturer's recommended torque.

  5. Locate the oil filter and remove it using an appropriate wrench or tool.

  6. Install a new oil filter according to the manufacturer's instructions.

  7. Refill the engine with the recommended type and amount of fresh oil, as specified in the motorcycle's owner's manual.

  8. Check the oil level using the dipstick or sight glass, and adjust if necessary.

By following these steps and avoiding running the motorcycle during the oil change, you can ensure a proper and effective oil change while minimizing risks and maintaining your safety.

Welcome to Askmotopros Q&A, where you can ask any question about motorcycles
...