+20 votes
in Harley Davidson Motorcycles by
edited by

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
+6 votes
by

To change the oil on a 2000 Harley Davidson Fatboy, you will need the following tools and materials:

  1. New oil filter
  2. New oil
  3. Drain pan
  4. Socket wrench
  5. Oil filter wrench
  6. Funnel
  7. Shop towels

Here are the steps to change the oil on your 2000 Harley Davidson Fatboy:

  1. Start the motorcycle's engine and let it run for a few minutes. This will warm up the oil and make it easier to drain.

  2. Locate the oil drain plug. On the Fatboy, it is usually located on the bottom of the engine, towards the front. Place the drain pan beneath the drain plug to catch the old oil.

  3. Use a socket wrench to remove the oil drain plug. Be careful as the oil may be hot. Allow the oil to drain completely into the pan.

  4. Once the oil has drained, clean the drain plug with a shop towel and inspect it for any damage or debris. Replace the drain plug if necessary.

  5. Locate the oil filter. It is typically located on the front or side of the engine. Use an oil filter wrench to loosen and remove the old oil filter. Be prepared for some oil to spill when removing the filter, so ensure the drain pan is still in place.

  6. Take your new oil filter and apply a thin layer of oil to the rubber gasket on the top of the filter. This helps create a proper seal and makes it easier to remove during the next oil change.

  7. Install the new oil filter by hand, turning it clockwise until it is snug. Do not overtighten the filter, as it can make it difficult to remove later.

  8. Clean the area around the oil filter and ensure there are no oil leaks. Wipe away any spilled oil with a shop towel.

  9. Now it's time to add new oil. Check your motorcycle's manual for the recommended oil type and capacity. Using a funnel, slowly pour the new oil into the oil fill port, which is typically located on the side of the engine.

  10. Once you've added the recommended amount of oil, replace the oil fill cap.

  11. Start the motorcycle and let it run for a few minutes to circulate the new oil. Check for any leaks around the drain plug and oil filter.

  12. Turn off the motorcycle and allow it to sit for a few minutes. Then, check the oil level using the dipstick or sight glass. Add more oil if needed, but be careful not to overfill.

  13. Clean up any oil spills, dispose of the old oil properly, and recycle the oil filter according to local regulations.

By following these steps, you should be able to successfully change the oil on your 2000 Harley Davidson Fatboy. However, it's always a good idea to consult your motorcycle's manual for any specific instructions or recommendations.

Welcome to Askmotopros Q&A, where you can ask any question about motorcycles
...