To start a motorcycle, including a Harley-Davidson, without giving it excessive gas, you can follow these steps:
Ensure the motorcycle is in neutral: Make sure the motorcycle is in neutral gear by shifting the transmission into the neutral position. This allows the engine to start without any resistance from the transmission.
Ensure the kill switch is in the "Run" position: Locate the kill switch on the handlebars, typically on the right side. Ensure it is in the "Run" position, which allows electrical power to flow to the engine.
Apply the choke (if necessary): If the engine is cold, you may need to engage the choke to enrich the air-fuel mixture. Refer to your motorcycle's manual to locate and use the choke lever or knob properly.
Turn the ignition key: Insert the key into the ignition switch, typically located near the handlebars, and turn it clockwise to the "On" position. This powers the electrical system of the motorcycle.
Activate the starter: Locate the starter button, typically on the right handlebar. Firmly press and hold the starter button until the engine starts. Avoid excessive throttle input while starting the motorcycle. The engine should start smoothly without the need for excessive gas.
Release the starter button: Once the engine starts, release the starter button. The engine should idle smoothly on its own. Allow it a few moments to warm up before riding.
Remember, each motorcycle model may have slight variations in starting procedures, so it's always best to consult your motorcycle's owner's manual for specific instructions tailored to your particular Harley-Davidson model.